Standard seals for SNLN 30 plummer block housings

Seal
Type	Four-lip split	V-ring	Felt split	Labyrinth	Taconite	Taconite	End cover	End cover
Designation	TSN .. L	TSN .. A	TSN .. C	TSN .. S	TSN .. ND	TNF ..	ASNH ..	ETS ..
Size range for adapter sleeve mounting	3024 to 3032	3024 to 3032	3024 to 3032	3024 to 3056	3024 to 3032	3024 to 3056	3024 to 3032	3024 to 3056
Size range for cylindrical seat mounting	224 to 230	224 to 232	n/a	224 to 232, 3034/185 to 3056/295	224 to 232	3034/185 to 3056/295
Material	thermoplastic polyesterelastomer	nitrile rubber, steel	felt, nitrile rubber, aluminium	steel or cast iron, silicone	steel, nitrile rubber	steel, nitrile rubber	polymer	cast iron, silicone
Seals per pack	2 seals	2 seals	2 seals	1 seal	1 seal	1 seal	1 end cover	1 end cover
Application conditions and requirements
Temperature [°C]	–40 to +100	–40 to +100	–40 to +100	–50 to +200	–40 to +100	–40 to +100	–40 to +110	–50 to +200
Temperature [°F]	–40 to +210	–40 to +210	–40 to +210	–60 to +390	–40 to +210	–40 to +210	–40 to +230	–60 to +390
Max. circumferential speed1) [m/s]	13	72)	4	not limited	12	12	n/a	n/a
Max. misalignment [°]	0,5	1 to 1,5	0,5	0,3	0,5	0,3	n/a	n/a
Low friction	++	++	–	++	+	+	n/a	n/a
Axial shaft displacement	++	–	++	+	+	+	n/a	n/a
Vertical shaft arrangement	+	++3)	––	––	–	–	++	++
Replacement	++	–	+	–	–	–	++	++
Shaft tolerance class	h9Ⓔ	n/a	h9Ⓔ	h9Ⓔ	h9Ⓔ	h9Ⓔ	n/a	n/a
Shaft roughness Ra [µm]	≤ 3,2	n/a	≤ 3,2	≤ 3,2	≤ 3,2	n/a	n/a	n/a
Sealing suitability
Dust	++	+	–	–	++	++	++	++
Fine particles	++	+	–	+	++	++	++	++
Coarse particules	++	+	+	+	++	++	++	++
Chips	+	––	+	++	++	++	++	++
Liquids when sprayed	+	+	–	––	++	++	++	++
Direct sunlight	+	––	++	++	++	++	++	++

Symbols: n/a not applicable, ++ very suitable, + suitable, – limited suitability, –– unsuitable

1. 1) To convert circumferential speeds to rotational speeds, refer to this table.
2. 2) Higher speeds are permissible if the V-ring is located axially on the shaft.
3. 3) When the V-ring of the lower seal is mounted inboard