SKF precision lock nuts
| Precision lock nuts | ||
 |
|
|
|
KMT/KMTA Precision lock nuts with locking pins |
KMD Precision lock nuts with axial locking screws |
|
| KMT
thread 10 to 200 mm (sizes 0 to 40) |
KMD
thread 20 to 105 mm (sizes 4 to 21) |
|
| KMTA
thread 25 to 200 mm (sizes 5 to 40) | ||
| Maximum axial run-out (up to size 40) between the locating face and thread : 0.005 mm | Maximum axial run-out between the locating face and thread: 0.005 mm | |
| Can be adjusted to compensate for slight angular deviations | Effective axial locking, simple to position | |
| Reusable | Reusable | |
| Simple to install and remove | Simple to install and remove | |
| For shaft threads without keyways | For shaft threads without keyways | |
| Designed for frequent installation and removal | Designed for frequent installation and removal | |
| High axial load capacity | ||
|
|
|
| Locks to the shaft thread by friction generated by tightening three radial locking pins with grub screws against its unloaded flanks | Locks to the shaft thread by friction generated by tightening four axial screws that press the rear part of the nut against the unloaded thread flank | |
